![]() ![]() When capture the GS, set Airspeed to flap5 placard speed+5 then set flap to 15.Once you capture localizer then set speed to flap1 placard speed+5 and set flap to 5.Press APP button at place 3nm to APP-4. ![]() Set FlapUP placard speed+5 when you reach 3200AGL. Equipment->Radio settings, Set 109.50 of KMIA 27 ILS frequency to Nav1.Around 10000ft, turn on the landing light.When pass the transition altitude (FL14) press STD button and adjust QNH to KMIA pressure.When ship reaches TOD, automatically start to descent with 0.78M or 280Knot.If you get “Reset Altitude” warning message you may not use VNAV any more so please use normal Autopilot such as V/S or FLCH mode till approach. Once reach to the cruise altitude and before you reach the TOD(Top Of Descent) (Green circle on route ), set Altitude counter to 2500 (Arrival airport AGL 2500, this time KMIA elevation is 8ft thus 2500ft).When you pass the FL14(Japan) or FL18(USA)(You can change in Autopilot Control menu), press STD button to set STD to QNH.Around 10000ft, turn off the landing light.Now ship follows LNAV course and climb to cruise altitude by VNAV.Once ship stable without any force apply to control, then press AP.Wait until gear up, then adjust pitch trim to maintain F/D pitch bar center.Keep pitch angle 15deg then gear up when V/S ind plus.Advance thrust lever to half way then press Ctrl-t to engage A/T to TO/GA mode.Once you are on runway 08R, then press Heading HOLD button to set heading to runway heading. ![]() Turn on Landing Light, Logo light and Wing light.Make sure no warning light is lit on overhead panel.When engine starts and is stable, continue to Right engine as well.Once engine start to rotate, set left FUEL CONTROL switch on pedestal to RUN.Rotate SEAT BELTS knob to ON 4 times to notice cabin crew to close door and set door mode to auto.Press and hold center button of mouse on IAS knob you can decrease the value. You can check with /instrumentation/weu/state/v2. Left click on AUTO to 1000 then press and hold the left button or scroll center button on left lower of knob to adjust. Set cruise Alt to MCP Altitude counter to 41000.You may close Map or keep it open with Transparent to check course.Press Activate button then Close Route Manager.Now you can save this route for later use.Be careful that if you have heavy weight you can not reach high altitude and of cause if you don't have enough distance you can not reach that cruise altitude ether and that will cause VNAV not available. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |